SECURE MOUNTING
A disposal that isn't seated correctly in its mounting assembly will loosen and vibrate under load, eventually leaking at the sink flange. We set and tighten the mounting ring so the unit stays secure.
Installation
Garbage disposal installation and replacement, including mounting, drain alignment, and dishwasher hookup done to prevent leaks.
Experienced and Licensed Professionals
Tailored Solutions for All Plumbing and Drain Needs
Quality Workmanship
Timely Project Completion
A garbage disposal that isn't mounted securely or aligned properly with the drain will leak, vibrate loudly, or work loose over time. Spartan Plumbing and Drain installs disposals with attention to the mounting assembly, drain trap alignment, and electrical connection, since problems in any one of these areas lead to the leaks and noise complaints we're most often called out to fix.
If your kitchen has a dishwasher, we also confirm the disposal's dishwasher inlet is connected correctly and that the knockout plug was removed, a step that's easy to miss and causes the dishwasher to back up if overlooked. We size the drain trap and tailpiece to match the disposal's outlet so wastewater flows without pooling under the sink.
Whether you're installing a disposal for the first time or replacing a unit that's failed, we handle the mounting, electrical, and plumbing connections as a complete job.
Benefits
A disposal that isn't seated correctly in its mounting assembly will loosen and vibrate under load, eventually leaking at the sink flange. We set and tighten the mounting ring so the unit stays secure.
The disposal's outlet needs to line up with the drain trap without excess strain on the connections. We fit the trap and tailpiece to the specific unit so wastewater drains properly and joints aren't stressed.
When a dishwasher drains through the disposal, the internal knockout plug must be removed and the inlet connected correctly. We verify this during installation so the dishwasher drains as intended.
Disposals need a properly wired switch and connection point, whether hardwired or plugged in. We confirm the electrical setup matches the unit's requirements before it's put into service.
What We Do
Installation of a new disposal unit under an existing sink, including mounting assembly setup, drain trap fitting, and electrical connection for units that don't yet have one in place.
Removal of an old or failed disposal and installation of a new unit, reusing existing mounting hardware where suitable or replacing it if worn or incompatible with the new model.
Connection of dishwasher drain lines to the disposal's inlet port, including removal of the internal knockout plug so the dishwasher drains correctly without backing up.
Installation of a higher horsepower or larger capacity disposal for households that need more grinding power, including confirming the electrical circuit can support the upgraded unit.
Our Service Areas
Our Process
We listen first — what you are seeing, how long it has been happening and what outcome you need.
We inspect the system and identify the true cause instead of guessing at the symptom.
You get clear options and firm pricing in writing. Nothing starts until you approve it.
The work is completed to code, on schedule and with your property protected and cleaned up.
We test the results, walk you through what we did and follow up to confirm everything is holding.
Call in a Spartan. Straight answers, honest pricing and work that holds up.